PRO SCOOTERS
Scooter BARS
Scooter FORKS
Scooter WHEELS
Scooter DECKS
Scooter BRAKES
Scooter CLAMPS
Scooter HELMETS
Scooter PEGS
Scooter GRIPS
Scooter COMPRESSION
Scooter BAR WRAP
Scooter BEARINGS
Scooter GRIP TAPE
Scooter HEADSETS
Scooter HARDWARE
Scooter TOOLS
LUCKY STICKERS
LUCKY APPAREL
GIFT CERTIFICATES $$

Newsletter

Email Address:

Click here to unsubscribe
Lucky Scoot Knowledge Base:  
Knowledge Base > Technical, Maintenance and Compatibility Issues --> Knowledge Base > Technical, Maintenance and Compatibility Issues
How do you install a bar wrap?
Last Updated: 04/23/2013
We get a lot of emails regarding instructions on how to install a bar wrap the right way. To start make sure the wrap and scooter are room temperature.  You will need something to make a patten of your bar.  Trim a pattern to fit the upright first then the crossbar. You don't need wrap to go under your grips.

Transfer the pattern to the back of the wrap and cut out with scissors. Start at the top of the upright portion and peel the backing down and slowly apply to the tube, working down and around the tubing. smooth out any air bubbles with your thumbs.

Place the crossbar piece centered and work it out and around the tube peeling the backing as you go. Again smooth any air pockets as you go.

Patience is the key. Go Lucky!!


Was this article helpful?

Comments:
 

Related Articles
 > Threaded vs Threadless forks
 > Do your forks fit on a Razor Pro model headtube?
 > WHICH AXLE DO I NEED FOR MY LUCKY PEGS?
 > HOW WIDE SHOULD I GET MY BARS?
 > ARE YOUR LUCKY SCOOTER BARS THREADED?
 > WHAT ARE YOUR PARTS MADE OF?
 > WHAT IS THE HEADTUBE ANGLE ON THE EVO2 COMPLETE, LUCKY CLOVER, LUCKY STRATA AND LUCKY CREW?
 > IF I NEED SCS HOW SHOULD I ORDER MY BARS?
 > WHAT DO I NEED TO DO TO KEEP MY LUCKY SCOOTER MAINTAINED?
 > HOW DO YOU INSTALL SCOOTER GRIPS